connect by pushing the button on the router

The WPS will only light up when it is in a connection state. Do not think that your WPS is not functioning if you see the light turn off. NOTE: Once you enabled the WPS function, and connect using it, the WPS light will TURN OFF on your modem. We recommend reading: FAQ: When does clash start? Is the WPS light supposed to be on? The problem could be as simple as a faulty Ethernet cable. Your router or modem may be out of date, your DNS cache or IP address may be experiencing a glitch, or your internet service provider could be experiencing outages in your area. There are a lot of possible reasons for why your internet isn’t working. Then release the button and wait the Router to reboot to its factory default settings. To use WPS function, please push the button for less than 5 seconds, and then the WPS LED will flash to reset the router, please push the button for at least 10 seconds. If this is the case, reconnect your device to your router using the WPS Push Button method. If your router is not working after pressing the WPS button, check if the time has been exceeded 2 minutes from the time you have enabled the WPS feature on your device. Why did my WIFI stop working when I pressed WPS button? After a short period of time, your device and the wireless router will be connected.

Note: You will need to press and hold the WPS button on the wireless router for about 2- 3 seconds. Within 120 seconds, press the WPS button on the wireless router. Press the WPS button on the device you wish to connect. How long do you have to press the WPS button? NOTES: Most routers have a light that flashes while the connection is established. Depending on the router and the home configuration, it may take a few minutes to connect. Press the WPS button on the router to establish a connection. Should I press the WPS button on my router?

Connect by pushing the button on the router